Lindr font connection kit (Porta fonts – 3/16″)

Description

Lindr font connection kit for Porta fonts

Connects any Lindr portable unit to an external Porta draught beer font (or font with 3/16 beer inlet).

To fit this you first install your Porta font. Then disconnect the beer and gas lines from your Lindr unit. Remove the front beer font using the hooked tool from Lindr. Screw the stainless steel adapter to the front and connect the John Guest fitting (supplied). Then insert the supplied pipe to the front of the Lindr, cover this with the insulation and cut to the required length. Connect the flow control unit to the end of this, then connect the other end of the flow control to the beer inlet line on the Porta font and use the supplied insulation tape to cover as much exposed pipework as possible. Then connect your beer and your gas lines, switch everything back on and use the flow control to manage the speed of the beer entering the Porta font.

Kit includes:

• Genuine Lindr stainless steel font adapter – fits to the Lindr dispenser in place of the tap.
• Length of insulated 3/8 pipe.
• John Guest flow control with 3/8″ input and 3/16″ output to connect to the Porta 3/16″ beer line.
• Insulation tape.

Please note: This kit is for the Lindr portable range of units only – it is not needed for the AS or CWP models.